brother wireless printer connection error failed

You might get an error message “Connection: Failed” while initially setting up your Brother printer. This brother wireless printer connection error failed is prevalent for wireless Brother printers. Thus, connection failed error indicates that your printer is unable to communicate with your computer. 

You can encounter this error due to several reasons. In most cases, it appears due to an unstable connection between the printer and the computer. Similarly, it can occur when your printer fails to detect a WLAN access point or router which have WPS or AOSS enabled.  

Fix Brother Wireless Printer Connection Failed Error by Following Simple Steps

Here, we have provided the best methods to fix this issue in no time.

You have to go through each of these steps carefully to resolve the brother wireless printer connection error failed from your system. 

Method 1: Check the Router or Wireless Access Point 

Firstly, you have to check the Wireless Access Point or Router to fix this error. Thus, make sure that your router is turned on. Else, unplug your router and wait for a few seconds. Subsequently, plug it back in. Now, go through the following steps. 

Step 1: Check Internet Connectivity 

Afterward, check whether the Internet is working or not by testing it on your computer. Alternatively, you can bring the router closer to the printer if it’s found to be working fine. Make sure that your printer is not obstructed by anything between it and the router. 

Step 2: Establish the MAC Address

In case you notice the WLAN access point/router uses MAC address filtering, you need to confirm the same for your Brother Printer’s MAC address. You can locate the MAC address from the Network Configuration List. Thus, you have to enter this address as an exception in the router’s settings page.  

Step 3: Using the Setup Wizard

A Brother Printer works with radio signals in the 2.4 GHz range. This error may occur if your computer usage a 5 GHz range. In this situation, run the Setup Wizard from the control panel of your Brother printer and check if it fixes this error or not. 

Method 2: Manually Enter the SSID and Security Information

If you have provided the SSID and security information manually, it can happen that the information is incorrect. In this situation, you need to reconfirm the SSID and security information and if necessary, you need to provide the correct information. 

As a result, you need to check if the SSID, encryption method and Network Key (User ID/ Password) configured in the WLAN access point/router are correct. 

Method 3: Check WPS or AOSS Section

You can also check if the WPS or AOSS Section is correct or not. In order to use the  WPS or AOSS, make sure that your WLAN access point or router supports WPS or AOSS. 

  1. In order to check this point, ensure that your  WLAN access point/router contains the WPS or AOSS™ symbol. 
  2. In the next step, you need to configure your wireless settings using the WPS or AOSS. in this situation you need to know how to operate the WLAN access point or router using WPS or AOSS. 

Conclusion 

Finally, you should be able to resolve your Brother Printer from getting the connection failed error. Ensure that you have properly implemented the methods discussed above. However, you should avail of technical assistance if you’re still facing this issue.