brother printer error 30

Brother printer offers one of the finest quality printing but it is prone to errors and other printing problems as well. Out of these, the Brother printer error 30 is one of the most common issues that were faced by various users. 

Generally, this error is caused when a cartridge fails to go back to its original position in the far right. Additionally, it can occur when the cartridge is not locked properly in its place. Similarly, misplaced springs on either side of the cartridge can cause this issue as well. 

Best Solutions to Fix Brother Printer Error 30

Here, we are going to discuss some of the guaranteed solutions to fix Brother printer error code 30.

You can follow each solution one by one until your brother printer error 30 issue is resolved.  

Solution 1: Check the Scanner Cover

If there is any fault in the cover of the scanner then it might cause the Brother printer error 30. In such cases, you need to check the scanner cover. You can do this by following the instructions below. 

  1. The very first thing you have to do is to tap on the ink button that is situated in the “Control Panel”. After that, you should press down the “Replace Ink” icon that will prompt the “Pleas Open Cover” option.
  2. After choosing the previous option, you have to pull the Scanner Cover to release the lever out. Ordinarily, you will find this icon under the Control Panel tab.
  3. Now, you have to move the carriage towards the left side very carefully. Carefully, check for any dirt or debris in its path to ensure that it is able to go back to its original position.

Afterward, head on to the next solution fur further inspection. 

Solution 2: Check the Springs

Follow these instructions in continuation with the previous one. Otherwise, you have to turn off your printer and open the printer’s cover to move the cartridge from its place. 

  1. After moving the cartridge to the left, you have to press each and every cartridge cover down. Remember not to apply extra force while you are pressing down the cartridges. 
  2. Now, remove all the ink cartridges from your Brother printer carefully. Now, you will see there are two springs located on each side of the carriage. It helps to hold the print head against the carriage assembly.
  3. In case the springs are not set in their exact location and found to be out of place then you should press the spring back into its previous position. Do this for both the springs. Finally, turn on your printer and check the status of the error.

Solution 3: Re-Install the Cartridges

When the first two methods failed to solve the issue then the only way to resolve your issue is by reinstalling the cartridges. Thus, you have to go through the following steps. 

  1. After placing both the springs properly you have to close all the covers for checking they are locked securely into place. 
  2. Next, wait for a few minutes until the printer’s status changes to online. 
  3. Now, you might be prompted to check whether the ink cartridge is installed properly or not. Therefore, tap on the “2” button of your keyboard and wait a few seconds. Finally, check whether you are still getting the Brother printer error code 30 or not.

Conclusion 

The above-mentioned solutions should help you to get rid of the Brother printer error 30 on your own. However, you may need immediate technical support if you’re still facing this issue. It would indicate that your ink cartridge has faced a critical hardware issue and may need replacement from the service center.